Copymaster3D Magnetic Build Surface - 235 x 235 mm

Magnetic Build Surfaces from Copymaster3D are high quality, affordable build surfaces that are reliable time and time again. With hundreds of build surfaces out there to choose from, this should be your go to choose.

HIGHLIGHTS:

• Perfectly cut to 235 x 235mm to fit a wide variety of 3D Printers.
• Soft magnetic backing makes prints easy to remove.
• Quick heat up time compared to glass.
• Deep pores to aid adhesion.

MAGNETIC BUILD SURFACE 235 X 235 MM:

Buy this Copymaster3D Magnetic Build surface as a spare or replacement for your 3D printer. Cut to 235x235mm this will fit a wide variety of 3D Printers Including:

Ender-3, Ender-3 Pro, Ender-3 V2, Ender-5, Ender-5 Pro, Ender-3 S1, Ender-3 S1 Pro, Ender-3 NEO, Ender-3 V2 Neo and many more. You will get the print surface (Sheet A) and the bottom magnetic layer (Sheet B).

IT IS EASILY INSTALLED ON YOUR 3D PRINTER FOLLOWING THESE EASY STEPS:

Remove the backing on Sheet B. Stick this directly to your 3D Printers Heated Bed. Place Sheet A on top. Accurate bed levelling and offset adjustment is important, so you don’t damage your build surface.

Do not use any tape, adhesive sprays, or liquids. Clean your bed regularly by using a mild soapy water solution made with warm water.

 Together, Layer by Layer!